Posted: Sat Oct 01, 2005 10:34 pmMaybe I am looking at it wrong but it looks to me like if you laid it on the table flat, it would hold water?
Don
Don
Page 2 of 3
Posted: Sat Oct 01, 2005 10:34 pmPosted: Sat Oct 01, 2005 10:51 pmThe second photo of the center shows the corner up and the third photo shows what looks to be a shadow along the edge. If the edge were turned down I think the dark line would be absent.
Posted: Sun Oct 02, 2005 12:23 ambevel down? seems to me that would defeat the purpose of the bevel! Turn those babies up so the edge won't wear on the tedlar underneath! And the factory instructions call for a strip of 1/2" double face tape under each capstrip to avoid vibration rubbing between the capstrip and tedlar between rivets.
Posted: Wed Oct 05, 2005 9:15 pmInteresting posts. I had always thought that the bevels on the cap strips were ment to be installed up. If it's good enough for the factory......
Dave
Dave
Posted: Sun Oct 09, 2005 11:28 pmPosted: Tue Oct 11, 2005 9:43 pmPosted: Wed Oct 12, 2005 3:02 amPosted: Fri Oct 14, 2005 8:59 pmPosted: Sun Oct 16, 2005 5:09 amPosted: Sun Oct 16, 2005 1:20 pm