Page 1 of 1

PostPosted: Thu Sep 23, 2010 2:26 pm
by lazairiii
I just finished a small run of Spinner Backing Plates and I'm now thinking I should have done a larger run. I'm doing them out of billet aluminum. These are super nice and strong. I would like to run more than just a set or two to justify the material and machine costs on a second run.

These will fit OEM "Stacked Bi-Props" or the "Prince P-Tip" prop bolt pattern...and possibly others.

Cost will be $175/set plus shipping. USD

If interested, e-mail me offline: gcurtis@aspenpress.com

George

PostPosted: Tue Oct 12, 2010 2:58 pm
by Shannon
Just received my set of new spinner plates. Very nice ! Anyone still utilizing the old factory spinner plates should jump on these.

PostPosted: Tue Oct 12, 2010 2:59 pm
by Shannon
Nice fit !

PostPosted: Tue Nov 09, 2010 2:49 pm
by lazairiii
I've only had a couple of you interested in a set of these nice 1/8"+ thick spinner plates. If you're at all considering them, now's a good time.

I'd like to put this run together before the holidays since I'll be even busier then than I am now.

gcurtis@aspenpress.com