Page 1 of 5

PostPosted: Thu Oct 29, 2009 12:29 am
by Wayne
Here is a few pics of the aileron control for the Mk111.

PostPosted: Thu Oct 29, 2009 12:31 am
by Wayne
And here is the finished product.

PostPosted: Thu Oct 29, 2009 12:38 am
by Wayne
Can anyone identify these parts ?

PostPosted: Fri Nov 06, 2009 9:35 pm
by Wayne
Yes I have the complete jury upgrade kit and there is also a Battery/ electrics box for JPX or KFM as george has identified the 'G' parts that I have.
Can you tell me what the G235 'gusset tape' is for , do I have to replace the the plate that is already there with the elongated hole that allows the push rod to travel through, or can I put the original back on?
If I use the G235 it needs to be trimmed of cut to allow the push rod to pass without touching, so I would rather put the original back on any suggestion ?

PostPosted: Sun Nov 08, 2009 12:02 am
by Wayne
Ok, here is the pic with the old part in place and I'm holding the G235. I will put the old part back on, as it does not need any modification. I was thinking that I needed the G235.

PostPosted: Sun Nov 08, 2009 10:50 pm
by Wayne
G314 cap stap doubler ? can anyone post a pic of how this is positioned ? i need to put the Tedlar between the rib and doubler, since I only have tape which side would be better for the sticky side to be on, in or out, what is the purpose of the tedlar being there ?

PostPosted: Mon Nov 09, 2009 12:20 am
by Wayne
could I use the G235s round off the corners bent slightly, in place of the tedlar under the catstrap ? it would make a nice surface to work off and stick double sided tape/tedlar to the G235 ? any suggestions.

PostPosted: Mon Nov 09, 2009 1:09 am
by Wayne
I can't get the back off the tedlar tape is it supposed to stay on ? Heeeellp ! maybe after 25years it has become completly adhered to the backing paper ?.This time difference is not helping right now.

PostPosted: Mon Nov 09, 2009 4:13 pm
by Wayne
OK so how do I put these peices on my wing before the tedlar covering, then cover my wing, What is the method, if there is not a method then how can I cover the wing when these parts are already on the wing?

PostPosted: Mon Nov 09, 2009 4:22 pm
by lazairiii
Wayne,

Go to the files section of this site and download the Jury Strut instructions. That shows you clearly how the JS are to be mounted.

Let me know if this doesn't help,

George