Page 3 of 4

PostPosted: Thu May 27, 2010 5:47 am
by Shannon
You can see the "C" pieces between the G-25's in this pic.

PostPosted: Thu May 27, 2010 12:05 pm
by lazairiii
Shannon is right. Installing these "C" channels will greatly help.

When building from the start which I was able to do, this is how I did mine. I fabricated new ends.

PostPosted: Thu May 27, 2010 12:07 pm
by lazairiii
Another look...

PostPosted: Thu May 27, 2010 12:08 pm
by lazairiii
Fabric going on...

PostPosted: Thu May 27, 2010 12:09 pm
by lazairiii

PostPosted: Thu May 27, 2010 12:10 pm
by lazairiii

PostPosted: Fri May 28, 2010 10:31 pm
by Wayne
Glad to have the pics to reference, I can see how either way will work. thanks guys I'll play around and see how many rivets I have left, sorry Don I'll stick with the fabric for now as I'm not up on fibre glass methods and haven't done any before. Thanks again.


PostPosted: Sat May 29, 2010 6:07 am
by Don
That 's Ok Wayne for all the reasons Dave, Shannon and George gave and not to mention the just plain nice appearance is why I didn't use them. Good luck with your build.

PostPosted: Sun May 30, 2010 7:12 pm
by Wayne
George ,
I think I will go with your method as it provides a clean line and neat edge to apply the tapes/glue to.
Putting the G25 under the ASI is going to act like a large bracket that strengthens the whole area. I presume you have left those corner brackets in ? (can't see the lower one)
I noticed that you put a foam tape on the edge of the G25, and a cap strip between the tape and fabric.
Its all very neat and clean, I like it.
How did you get the 'wave' in the cap strips and did you do that to all of the cap strips?

where can I get some Lazair decals as I don't seem to have any?


PostPosted: Sun May 30, 2010 10:55 pm
by JPXman
a few dudes here can make you lazair decals. if nobody pans out for you, i have a shop that can make cut vinyl decals of the lazair logo. i think they make them for $50 each? i really can't remember though, been a few years.