Page 1 of 1

PostPosted: Wed Oct 06, 2010 11:16 am
by sobowolftrap
I am trying to put my Lazair ser ll back into it's original condition.
I hope someone can give me the lenghts of T7,T10,T31 & RSB.
Also is there a source for the F32 guides?
Any help would be appreciated

PostPosted: Fri Oct 08, 2010 8:54 am
by Shannon
Can you scan and post the pages from your manual showing the parts T-7, T-10, and T-31 as well as some pictures of the project ? I don't know what those parts are or have a manual that shows them ? RSB's are early tail design "top" of the tail c-channel pieces. The RSB's on an early produced Series III tail are approx. 36 inches long +/-. Mid to late Series II's and early Series III's have the same basic tail design. On later produced Series III's (Elites, and 2-seat also) the RSB's were replaced with tubes along with other changes.

There is no source for the F-32's other than what can be scavenged off parts planes. The F-32's were made by Ultraflight.

By the way where are you located ?

Pic below: Series III with RSB tail design.