Help! - Need Banana Pins and Temp Probes

Share your thoughts, photos and general help to all builders

Postby dynera » Wed Jun 16, 2004 7:13 pm

Howdy,

I'm just finishing a rebuild of my Rotax 185's. I need to replace the Banana pins and plugs on the engine electircal system. Does anyone know where I can find new ones? What size are they anyway?

Thanks in advance and keep flying!
dynera
Lazair.com Member
 
Posts: 5
Joined: Wed Jun 16, 2004 7:07 pm

Postby Guest » Thu Jun 17, 2004 1:46 am

Try radio shack. They should have them. The pin size is about 3/16"ishx1/2". Look at them in the store and you can guess which one it is...inexpensive part too! I'd get a couple spares to keep on hand while your there getting some.
Guest
 

Postby Guest » Thu Jun 17, 2004 4:05 pm

If you find some plugs please post your source here. Thanks !
Guest
 

Postby lazair » Fri Jun 18, 2004 5:18 am

lazair
LazairNUT
 
Posts: 345
Joined: Sat Aug 23, 2003 10:25 am

Postby Lazair_guest_please_registerdyne » Sun Jun 27, 2004 10:46 pm

Thanks for the info on the Banana Plugs. I ended up getting a set of four from Best Buy for $8.99. You can find them in their stereo department.
Lazair_guest_please_registerdyne
 

Postby flyalaz » Mon Jan 17, 2005 11:37 pm

Use solder even if the plug type is a screw on cinch type. The hole in the end is most likely waay too big for the normal 20 gauge wire, so double over the end that goes into the hole. A good idea would also be to add heat shrink tubing over the end to help seal and keep out dirt.

Cheers
User avatar
flyalaz
LazairNUT
 
Posts: 352
Joined: Tue Sep 30, 2003 3:18 pm
Location: Montreal, Canada


Return to Re-Building tips and info

Who is online

Users browsing this forum: No registered users and 7 guests

cron