tubing

Share your thoughts, photos and general help to all builders

Postby sobowolftrap » Wed Oct 06, 2010 11:16 am

I am trying to put my Lazair ser ll back into it's original condition.
I hope someone can give me the lenghts of T7,T10,T31 & RSB.
Also is there a source for the F32 guides?
Any help would be appreciated
Jack
sobowolftrap
Lazair Newbie
 
Posts: 2
Joined: Wed Mar 25, 2009 4:43 pm

Postby Shannon » Fri Oct 08, 2010 8:54 am

Can you scan and post the pages from your manual showing the parts T-7, T-10, and T-31 as well as some pictures of the project ? I don't know what those parts are or have a manual that shows them ? RSB's are early tail design "top" of the tail c-channel pieces. The RSB's on an early produced Series III tail are approx. 36 inches long +/-. Mid to late Series II's and early Series III's have the same basic tail design. On later produced Series III's (Elites, and 2-seat also) the RSB's were replaced with tubes along with other changes.

There is no source for the F-32's other than what can be scavenged off parts planes. The F-32's were made by Ultraflight.

By the way where are you located ?

Pic below: Series III with RSB tail design.
You do not have the required permissions to view the files attached to this post.
Shannon
SHANNON
 
Posts: 1082
Joined: Thu Jan 15, 2004 10:05 pm


Return to Re-Building tips and info

Who is online

Users browsing this forum: No registered users and 2 guests

cron