Tiny Check Ball part in Carb

General Messages Post you pics as well

Postby Lazair3 » Sat Oct 11, 2003 11:16 am

When changing the tiny brass check ball in carb be aware of this fact. The tiny brass valve goes in a certain way. Notice the porting holes the tiny valve. These holes need to be aligned with the porting hole in the carb housing. Before you tap a new valve in place scribe or mark a line across the flat bottom of the brasss valve the corresponds to its porting holes. Also mark the location of the porting hole on the carb housing. After you have tapped the new little valve in place check to see that the marks are in perfect alignment.
Lazair3
Lazair Newbie
 
Posts: 1
Joined: Wed Oct 01, 2003 9:53 pm

Postby Guest_bdiedenhofen » Sat Oct 11, 2003 7:58 pm

That's good advice, Thanks.
Guest_bdiedenhofen
 


Return to Lazair - General

Who is online

Users browsing this forum: No registered users and 8 guests

cron